1. Get rid of all advertisements and get unlimited access to documents by upgrading to Premium Membership. Upgrade to Premium Now and also get a Premium Badge!

rman - help me

Discussion in 'Security, Backup and Recovery' started by mithat, May 28, 2010.

  1. mithat

    mithat Active Member

    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    55
    Hi every body!

    I learning RMAN, when i configure parameters of rman for work backup and restore

    rman>CONFIGURE CONTROLFILE AUTOBACKUP FORMAT FOR DEVICE TYPE 'TAPE' TO '%F';

    After config, i see

    rman>
    .........
    CONFIGURE CONTROLFILE AUTOBACKUP FORMAT FOR DEVICE TYPE DISK TO '%F';
    CONFIGURE CONTROLFILE AUTOBACKUP FORMAT FOR DEVICE TYPE 'TAPE' TO '%F';
    .........

    Now, i want delete 1 parameter config for " configure controlfile autobackup format for device type disk to '%F'";
    Who is help me??
    Thank you very much!:hurray:hurray
     
  2. zargon

    zargon Community Moderator Forum Guru

    Messages:
    2,347
    Likes Received:
    348
    Trophy Points:
    1,430
    Location:
    Aurora, CO
    You don't need to delete that entry as it won't be used if you allocate tape channels. Leave it as it is would be my recommendation.
     
    mithat likes this.
  3. mithat

    mithat Active Member

    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    55
    Thank Zargon, i want to delete configure this line command.
    No command " CLEAR"!
     
  4. mithat

    mithat Active Member

    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    55
    :D :D I understanded, where the problem lies (delete lines configure)

    want to delete that line
    First, you delete parameter configure "CONFIGURE DEVICE TYPE 'DISK1' clear"
    Then, we begin delete " configure controlfile..., configure archivelog ...."
    If cleared " configure controlfile..., configure archivelog ...." then they will auto delete